The Water Inlet Valve on your own washing machine is used to fill the tub with cold, warm or hot water for the wash and rinse cycles. The valve is operated by electric solenoids that are controlled by the timer or electronic control board and the water level control/water level selector switch or pressure switch. If your washer continues to fill throughout a cycle, the water inlet valve could be at fault. To verify that the valve is at fault, unplug the washer when the symptom occurs. If washing machines repair continues to fill, then your water inlet valve is defective. If the washer stops filling, then your problem is related to the electrical circuit that controls the valve.
How to test the water inlet valve in a washer with a multi-meter:
Similar to other tests, make sure that you have disconnected the energy source from your own appliance before you begin, as you'll be handling electrical components.
Locate and remove your water inlet valve. It really is most often found directly behind the hose connections; you will have to take away the rear panel as a way to access it.
Visually inspect the valve for just about any signs of wear or damage. The valve has screens inside it, inspect these screens for just about any debris, do this carefully as these screens can't be replaced and when they get damaged you need to replace the complete valve.
With a multi-meter on Rx1, touch the probes to the valve`s terminals. The reading you need to receive varies from model to model, refer to your owner`s manual to find out what reading your test should produce.
If your valve is damaged or if your test outcomes do not match the recommended results, you will require an upgraded water inlet valve.